Zpao - Electric Bike Manual

Battery Charging: Charge the battery fully before your first ride. The indicator light on the charger will typically turn from red to green when finished. Operating the LCD Display and Controls

| Button | Short Press | Long Press | |--------|-------------|------------| | Power (M) | Cycle through trip, odometer, voltage | Turn bike on/off | | Up (+) | Increase PAS level | Headlight on/off | | Down (-) | Decrease PAS level | Walk mode (6 km/h) | Zpao Electric Bike Manual

| Error Code | In-Manual Definition | Real-World Fix | | :--- | :--- | :--- | | | Throttle fault | The throttle wasn't in zero position at startup. Turn bike off, twist throttle to release tension, restart. | | E-008 | Motor hall sensor error | Unplug the motor cable (near rear axle), clean with compressed air, re-plug. If persists, need new motor. | | E-010 | Controller communication failure | Check the cable from the display to the controller (inside the frame down-tube). Often a loose yellow connector. | | E-021 | Speed sensor error | The magnet on the rear spoke has shifted. Align it within 5mm of the sensor on the chainstay. | Battery Charging: Charge the battery fully before your