| Pin | DTE Signal | Function | | :--- | :--- | :--- | | 2 | TXD | Transmit | | 3 | RXD | Receive | | 5 | GND | Ground | (Standard RS-232; no need for full handshaking unless Jumper JP3 is set for hardware flow control).
If you have an original physical manual, consider scanning it to archive.org. For everyone else, bookmark this page. The next time your 1998 CNC press freezes on boot, you will know exactly which jumper to clear. Winfast 760m02 Gx 6ls Manual
Follow these sequential steps to safely set up and configure the hardware layout: Step 1: CPU and Cooler Installation | Pin | DTE Signal | Function |
Move the jumper to Pins 2-3 for about 5-10 seconds while the PC is powered off and unplugged, then return it to Pins 1-2. 4. Driver Support The next time your 1998 CNC press freezes
| Component | Driver Version | Source | | :--- | :--- | :--- | | Geode GX1 VGA | Display Driver v1.2 (Windows 95/98) | National Semiconductor Archive | | CS5530A IDE | Standard dual FIFO IDE driver | Windows 98 built-in | | Winbond Super I/O | Not required in DOS; Windows uses standard 16550 UART driver. | | PC/104 Watchdog | Requires manual memory map (usually I/O address 0x274). |
– Usually Del key. Sometimes F2 or F10 .