Last updated: October 2024. Specifications for the WBE RFT-200 driver are subject to change by the manufacturer. Always verify voltage ratings before installation.
Use the manufacturer-provided demo tool to test read/write capabilities and verify that the hardware is functioning independently of your main application. wbe rft-200 driver
| Parameter | Value | |-----------|-------| | Frequency Range | 13.56 MHz / 27.12 MHz (ISM band selectable) | | Output Power | 200W (CW) | | Gain | 50 dB typical | | Input VSWR | 1.5:1 max | | Harmonics | < -55 dBc | | DC Supply | 48V / 8A | | Cooling | Forced air (integrated fan) | | Interface | Analog (0-10V) / RS-485 | Last updated: October 2024
| Error Code | Meaning | Solution | | :--- | :--- | :--- | | | Over-current (instantaneous) | Check for short circuits in U/V/W wires. Motor winding resistance too low. | | Er-02 | Over-voltage | DC bus voltage > 400V. Add a braking resistor or decelerate slower. | | Er-03 | Under-voltage | AC input voltage dropped below 85V. Check your supply line or circuit breaker. | | Er-05 | Over-temperature | Heatsink exceeded 85°C. Clean dust from fan; reduce switching frequency. | | Er-08 | Hall sensor error | Feedback connector loose; Hall wires broken; incompatible motor type. | | Er-12 | Modbus timeout | PC software lost connection. Check RS485 termination resistors (120 ohm). | Use the manufacturer-provided demo tool to test read/write
This is where most "no response" issues occur.
Compatible with Windows XP, 7, 8, 10, and Linux. Driver Installation Guide