| Symptom | Likely Cause | Solution | |---------|--------------|----------| | LED stays red | No IP or DHCP failure | Check switch port VLAN, PoE, DHCP scope | | Cycling amber | Cannot find WLC | Verify Option 43, DNS, or Layer 2 adjacency | | Join fails with cert error | WLC date not set | Set correct NTP on WLC | | AP keeps rebooting | PoE insufficient (15.4W max) | Use 802.3at switch or power adapter | | After conversion, no radio up | Missing country code | ap country-code US (autonomous) |
If you plug this unit into your switch expecting a GUI setup page, you will hit a wall. This article provides a definitive, step-by-step walkthrough for setting up the AIR-CAP2602I-A-K9, covering factory resets, console access, DHCP options, and conversion to Mobility Express or Autonomous mode. cisco air-cap2602i-a-k9 setup
while reconnecting power. Hold for about 20 seconds until the LED turns amber or red. Default Credentials : The standard factory username is and the password is (case-sensitive). Default IP : Typically, the device requests an IP via | Symptom | Likely Cause | Solution |
: After saving, ensure the 2.4 GHz and 5 GHz radios are manually set to , as they are often disabled by default. Community Insights on Performance Hold for about 20 seconds until the LED turns amber or red
Before starting, determine if your AP has or Autonomous software.