The blade depth is correct, but the software is in "Pen" mode instead of "Cut" mode. Solution: In ArtCut6, go to Tool > Parameters and ensure "Knife Force" is set to 80-120g (for vinyl) and "Speed" to 30-50 cm/s.
The real power of ArtCut6 lies in its output window. This is where the physical cutting happens. Users have granular control over:
Artcut6 Plotter Software And Artcut Grapic Disc [better]
The blade depth is correct, but the software is in "Pen" mode instead of "Cut" mode. Solution: In ArtCut6, go to Tool > Parameters and ensure "Knife Force" is set to 80-120g (for vinyl) and "Speed" to 30-50 cm/s.
The real power of ArtCut6 lies in its output window. This is where the physical cutting happens. Users have granular control over: