To configure , you need to set up Port Address Translation using both a NAT Pool (on R1) and an Interface (on R2) . This process allows multiple internal devices to share a single public IP address by using unique port numbers. Part 1: Configure Dynamic NAT with Overload (on R1)
This method is common for small offices where only one public IP address is provided on the router's outside interface. : R2(config)# access-list 2 permit 172.17.0.0 0.0.255.255
Many students struggle with this lab. Here are the top issues and fixes:
Below is a general guide to the configuration steps required to complete this lab. Note that specific IP addresses may vary slightly depending on the exact version of the curriculum, but the logic remains identical.
On the PAT router (e.g., Gateway ), check that the inside and outside interfaces are correctly labeled and addressed.
The command syntax is: ip nat inside source static tcp <private_ip> <private_port> <public_ip> <public_port>
To configure , you need to set up Port Address Translation using both a NAT Pool (on R1) and an Interface (on R2) . This process allows multiple internal devices to share a single public IP address by using unique port numbers. Part 1: Configure Dynamic NAT with Overload (on R1)
This method is common for small offices where only one public IP address is provided on the router's outside interface. : R2(config)# access-list 2 permit 172.17.0.0 0.0.255.255 6.6.7 packet tracer - configure pat.pka
Below is a general guide to the configuration steps required to complete this lab. Note that specific IP addresses may vary slightly depending on the exact version of the curriculum, but the logic remains identical. : R2(config)# access-list 2 permit 172
On the PAT router (e.g., Gateway ), check that the inside and outside interfaces are correctly labeled and addressed.
The command syntax is: ip nat inside source static tcp <private_ip> <private_port> <public_ip> <public_port>