Mks Gen V1.4 Klipper Today

PID_CALIBRATE HEATER=extruder TARGET=210 PID_CALIBRATE HEATER=heater_bed TARGET=60 SAVE_CONFIG

[mcu] serial: /dev/serial/by-id/usb-FTDI_FT232R_USB_UART_XXXXX-if00-port0 restart_method: command mks gen v1.4 klipper

The primary limitation of the MKS Gen v1.4 is its 16MHz clock speed. When running Marlin, the processor must handle both the high-level logic (G-code parsing, thermal regulation) and the low-level execution (stepping the motors). At high speeds, the board literally runs out of "thinking time," leading to stuttering. mks gen v1.4 klipper

[respond] default_type: command