Cwfl-6000 Manual

| Code | Cause | Solution | | :--- | :--- | :--- | | | High water temp | Check radiator fins, clean filter, ambient too hot. | | E2 | Low water temp | Increase set temperature. | | E3 | Water flow failure | Check pump, clean filter, check for air in line, verify water level. | | E4 | High pressure (refrigerant) | Clean condenser fan/coils. | | E5 | Low pressure (refrigerant) | Call technician – gas leak. | | E6 | Phase loss / reverse phase (3-phase models) | Swap any two input power wires (L1, L2). | | AL | Water level low | Refill distilled water. |

Place the chiller on a level, dry, and well-ventilated surface. Ensure at least 50 cm distance from air outlets to obstructions and 30 cm from air inlets. cwfl-6000 manual

The official provides a schematic of installation, but experienced technicians know that the setup process requires attention to detail to avoid future leaks or electrical faults. | Code | Cause | Solution | |

Compatible with: 6kW Fiber Laser Cutting/Welding Machines | | E4 | High pressure (refrigerant) |

Before downloading the CWFL-6000 manual, you must understand what this machine does. Unlike domestic water coolers, the CWFL-6000 is a dual-circuit, dual-temperature refrigeration chiller specifically designed for high-power fiber lasers.

: Avoid using combustible fluids, automobile antifreeze, or oil-based fluids. Anti-freezing